WILLIT® S-WS
Single-component, cement-based, ready-to-use dry-mix mortar
Product description
WILLIT® S-WS is used to instantly:
- Seal water ingress points in rock, concrete and masonry
- Create a waterproof seal between floor surfaces and rising masonry
- Create a waterproof seal against flowing water, even if submerged
Technical specifications
Processing time at 20°C [s] | 30 |
TDS & MSDS on request |
PROCESSING
Mix WILLIT® S-WS with the specified quantity of water to create a workable, easily formable mixture. The mixing time is approx. 15 seconds. It sets after approx. 30 seconds Form a plug from the mixture and hold it on a trowel or in your hand (wearing rubber gloves) until it begins to heat up. In a single motion, press this plug firmly into the cavity and hold it still until the water stops flowing. When sealing longer cracks, work from the top down to the bottom. Remove excess material flush with the surface. Afterwards, keep the repaired area wet for 15 minutes.
Packaging units
Plastic bucket 25 l | 15 Kg |
Other delivery forms on request |
CONTACT
NICOLAS HOUY
E-Mail: | nicolas.houy(at)f-willich.de |
Phone: | +49 6873 9999 216 |
Mobile: | +49 173 146 27 32 |
JÜRGEN SCHOLZ
E-Mail: | juergen.scholz(at)f-willich.de |
Mobile: | +49 174 195 10 94 |